University of Illinois at Chicago
A 3D-Printed Oxygen... 24-Well Plate.PDF (957.13 kB)
Download file

A 3D-printed oxygen control insert for a 24-well plate

Download (957.13 kB)
journal contribution
posted on 2016-08-29, 00:00 authored by M. D. Brennan, M. L. Rexius-Hall, D. T. Eddington
3D printing has emerged as a method for directly printing complete microfluidic devices, although printing materials have been limited to oxygen-impermeable materials. We demonstrate the addition of gas permeable PDMS (Polydimethylsiloxane) membranes to 3Dprinted microfluidic devices as a means to enable oxygen control cell culture studies. The incorporation of a 3D-printed device and gas-permeable membranes was demonstrated on a 24-well oxygen control device for standard multiwell plates. The direct printing allows integrated distribution channels and device geometries not possible with traditional planar lithography. With this device, four different oxygen conditions were able to be controlled, and six wells were maintained under each oxygen condition. We demonstrate enhanced transcription of the gene VEGFA (vascular endothelial growth factor A) with decreasing oxygen levels in human lung adenocarcinoma cells. This is the first 3D-printed device incorporating gas permeable membranes to facilitate oxygen control in cell culture.


This work was supported by National Science Foundation 1253060, DTE (http://www.nsf. gov/awardsearch/showAward?AWD_ID=1253060).


Publisher Statement

This is a copy of an article published in the PLoS ONE.


Public Library of Science


  • en_US



Issue date


Usage metrics


    No categories selected