University of Illinois at Chicago
sensors-12-08770.pdf (318.48 kB)

Comparisons between Membrane, Bridge and Cantilever Miniaturized Resistive Vacuum Gauges

Download (318.48 kB)
journal contribution
posted on 2013-12-03, 00:00 authored by Kasun Gardiye Punchihewa, Evan Zaker, Rade Kuljic, Koushik Banerjee, Tatjana Dankovic, Alan Feinerman, Heinz Busta
Abstract: Using bulk micromachining, meander-shaped resistor elements consisting of 20 nm Cr and 200 nm Au were fabricated on 1 µm thick silicon nitride membranes, bridges, and cantilevers. The resistance change as a function of pressure depends strongly on the thermal resistance of the two metal lines connecting the heated resistor to the silicon bulk (cold junction) and on the thermal resistance of the silicon nitride. Relative resistance changes ranging from about 3% (small membrane) to 20% (bridge) per mW of input power were obtained when operating the devices in constant voltage mode. The pressure where maximum sensitivity of these gauges occurs depends on the distance ‘d’ between the periphery of the heated resistor element and the silicon cold junction. Devices with ‘d’ ranging from 50 µm to 1,200 µm were fabricated. Assuming that pressures can be reliably measured above the 10% and below the 90% points of the resistance versus pressure curve, the range of these devices is about two orders of magnitude. By integrating two devices, one with d = 65 µm and one with d = 1,200 µm on the same chip and connecting them in series, the range can be increased by about a factor of three. By fabricating the cantilever devices so that they curl upon release, it will be shown that these devices also exhibit larger range due to varying ‘d’.


Publisher Statement

© 2012 by the authors; licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution license. This is a copy of an article published in the Sensors © 2012 MDPI.




  • en_US



Issue date


Usage metrics


    No categories selected


    Ref. manager